User guide

821042: RMT-170e Series User Guide

RMT-170e HD Series User Guide

Using the OSD Menu

A description of how to use the OSD Menu follows. Also refer to Table

1–13 below for typical values and domain range.

1. Press the Menu button to display the menu.

2. Use the Up and Down buttons to navigate through the seven

sub-menu icons. The sub-menus are:

A. STATUS

B. COLOR TEMP

C. MARKER

D. VIDEO CONFIG

E. AUDIO CONFIG

F. USER CONFIG

G. CONTROL

3. Press the Enter button to enter the parameter selections in the

chosen sub-menu.

4. Use the Up or Down buttons to cycle through the sub-menu

selections.

5. When the desired option is highlighted, press the

Enter button to

select it.

6. Use the Up or Down buttons to adjust the parameter value up or

down, make a selection, or turn a function on or off.

7. Press the Enter button to save the parameter change and return to

the sub-menu level.

Press the Menu button to back out of a parameter or sub-menu. Press

the

Menu button again to remove the menu from the screen.

Note:

If you do not press another button for approximately 10

seconds, the menu will disappear from the screen.