User guide

821042: RMT-170e Series User Guide

RMT-170e HD Series User Guide

Rear Panel Connectors

• SDI Inputs 1 and 2: SD-SDI input signal on BNC jacks.

• SDI Output: Output jack for selected SDI signal.

• Line 1 (Video): Input jack for analog composite video signal only.

• LINE2 (Video/Y): Input jack for analog composite video input

signal, or luminance (Y) signal of Y/C or YPrPb.

• Line 2 (C/Pb): Input jack for Chroma (C) signal of Y/C or Pb (Blue)

component of YPrPb.

• Line 2 (Pr): Input jack for Pr (Red) component of YPrPb.

• Config I/O (on DB-9): Remote connector for factory programming

and configuration access.

Figure 1–5 DB-9 Connector Pin-Out

Table 1–10 GPI/Tally Lamp Color/Pin Designations

Tally Lamp Color GPI 1 Pin GPI 2 Pin

Green GND Open

Red Open GND

Orange GND GND

Table 1–11 GPI/Tally Lamp Connector Pin Out

Pin Function

1. GPI 1

2. GPI 2

3. GPI 3

4. GPI 4

5. GPI 5

6. GPI 6

7. No Connection (NC)

8. Ground