Product Specs

4
□文件新增 Addition of Document ■文件變更 Alteration of Document □文件作廢 Revocation of Document
Subject: Doc. No.: Rev: 0.6
UMC-STD31BPN Product Specification Page 52 of 55
本資料為啟碁科技股份有限公司專有之財產，非經書面許可，不准透露或使用本資料，亦不准複印，複製或轉變成其他形式使用。
The information contained herein is the exclusive property of WNC and shall not be distributed, reproduced, or disclosed in whole or in part without prior written permission from WNC.
Form No.: 2-JT-00022-03_001
UMC-STD31BPN Product Specification
52
This module is intended for OEM integrators only. Per FCC KDB 996369 D03 OEM Manual v01 guidance, the
following conditions must be strictly followed when using this certified module:
KDB 996369 D03 OEM Manual v01 rule sections:
2.2 List of applicable FCC rules
This module has been tested for compliance to FCC Part 27, 22, 24, 90
2.3 Summarize the specific operational use conditions
The module is tested for standalone mobile RF exposure use condition. Any other usage conditions such
as co-location with other transmitter(s) or being used in a portable condition will need a separate
reassessment through a class II permissive change application or new certification.
2.4 Limited module procedures
Not applicable.
2.5 Trace antenna designs
Refer to “Operational Description Antenna trace”
Please contact the module supplier
2.6 RF exposure considerations
This equipment complies with FCC mobile radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 21cm between
the radiator & your body. If the module is installed in a portable host, a separate SAR evaluation is required
to confirm compliance with relevant FCC portable RF exposure rules.
2.7 Antennas
The following antennas have been certified for use with this module; antennas of the same type with equal
or lower gain may also be used with this module. The antenna must be installed such that 21cm can be
maintained between the antenna and users.
Antenna Type
Dipole
Antenna connector
SMA
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following: “Contains FCC ID: NKRUMC-
STD31BPN”. The grantee's FCC ID can be used only when all FCC compliance requirements are met.
2.9 Information on test modes and additional testing requirements
This transmitter is tested in a standalone mobile RF exposure condition and any co-located or simultaneous
transmission with other transmitter(s) or portable use will require a separate class II permissive change re-
evaluation or new certification.
2.10 Additional testing, Part 15 Subpart B disclaimer
This transmitter module is tested as a subsystem and its certification does not cover the FCC Part 15 Subpart
B (unintentional radiator) rule requirement applicable to the final host. The final host will still need to be
reassessed for compliance to this portion of rule requirements if applicable.
As long as all conditions above are met, further transmitter test will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements
required with this module installed.