User manual

53
User Manual WMF1200S
Care
 Remove the water filter, if used
 Mix the two bottles of liquid descaling agent in the
water tank with 1bottle of warm water
 If crystals have formed when stored below the freezing
point, stir until all crystals present in the liquid
descaling agent have dissolved
 Replace water tank filled with descaling solution
 Place acollection container with approx. 5litres
capacity under the combi spout
Descaling
Descaling starts. Duration approx. 13minutes.
 After descaling, carefully empty the collection container
 Replace the collection container
 Empty remaining descaling solution from water tank
 Rinse water tank and fill to maximum with clean, cold
tap water. See the markings on the outside of the water
tank.
 Replace the water tank
Rinsing
Rinsing starts. Duration approx. 22minutes.
 When requested refill with cold tap water
(afterabout11minutes)
 Empty the collection container and place under the
combi spout
If awater filter is used, amessage appears after the
process is complete, with arequest to re-install the water
filter.
 Insert the water filter
 Fill water tank with clean cold tap water
The water filter is rinsed briefly.
After the final rinsing the steam boiler is heated up. The
hot water expands and finally exits briefly as steam.
As soon as the descaling procedure is finished, the “Ready
to operate” display appears.
 Remove the collection container
 Re-install the milk hose
Crystals may form in the liquid
descaling agent when stored.
The crystals must not enter the
machine.
The ideal water temperature is
approx. 37°C.
Order numbers of the article
w Accessories and spare parts
page 72
Caution.
Hot steam.
Observe the Safety chapter.
your selection pls
08:15 02.05.2012