Operating instructions

2. Remove the milk intake hose by pulling it all the

way through the hose device 5 towards the

combination

spout 6.

3. Clean the connector to which the combination

spout 6 was fitted with a damp cloth.

4. Dismantle the combination spout 6 and clean it

thoroughly under running warm water (until the

water runs clear).

5. Clean the ducts using the pipe cleaner supplied

(order no. 33 0350 0000) and the cleaning brush

(order no.

33 1521 9000).

6. Next, place all loose parts (including the pipe

cleaner, cleaning brush, milk intake hose, nozzle

and connector) in a cleaning solution for at least

5 hours. To prepare the cleaning solution, place

5 ml WMF special cleaner (order no. 33 0683

6000) from the measuring bottle in a container

with 0,5 l of hand-hot water and mix the

solution. The parts must be completely

covered by the cleaning solution. After this

time, the parts are sterile. Please take care not to

introduce any new germs during the steps that

follow.

7. Rinse the parts thoroughly under running

(preferably warm) water.