User manual

73
User Manual WMF8000S
Appendix: Technical data
Mains voltage
tolerancerange
230V +6 % and–10 % / 400V +6 % and–10 %.
Mains voltage interruption < 50ms: no interruption of
function
Water supply
TW15 (DN 15at least DN 6or 1/4“) hose connector with main
shutoff valve and contaminant filter, with amesh size of 0.2to
0.25mm, by customers on-site.
At least 0.05MPa (0.5bar) flow pressure at 2l/min
(lowpressure). At least 0.30MPa (3.0bar) flow pressure at
2l/min (standard).
Maximum 0.6MPa (6bar).
Maximum inlet temperature 35°C.
The set of hoses provided with the new coffee machine and/or
the new water filter must be used. Do not use old hoses.
Water quality
For drinking water with carbonate hardness above 5 °dKH,
aWMFwater filter should be fitted upstream.
Water drain tube
Tube aminimum of DN 19, minimum downward slope of
2cm/m
Ambient temperature
+5°C to maximum +35°C (empty the water system in case of
frost).
Maximum humidity
80 % relative humidity without condensation.
Do not use device outdoors.
Degree of protection
IP X0
Installation surface
The device must be placed on alevel, flat, and sturdy surface.
The device is not intended to be located on asurface that
is sprayed or cleaned with awater hose, steam jets, steam
cleaner, or similar devices.
Installation clearances
For operating, service, and safety reasons the machine should
be installed with aclearance of not less than 50mm at the
sides from the building or non-WMFcomponents. Aminimum
working space of 800mm in front of the coffee machine is
recommended. Aclear height of 1,100mm from the top of
the supporting surface should be ensured. The height of the
installation surface above the floor is at least 850mm. If the
coffee machine connections are to be run downwards through
the counter, please make space for the pipes, which can reduce
the usable space below the machine.
Installation dimensions
of the water filter
See the User Manual for the water filter.