User manual

28
Settings
Water volume
Example: press the plus button until the water volume is increased to 37 ml
>
You can start a preparation test with the new values at any time.
Place an appropriate cup under the All-in-One spout
>
Press the beverage button again >
Test the beverage >
If the beverage is to your taste, confirm the settings by pressing the P button >
Coffee strength
The grinding quantity varies depending on the grinding degree setting, the type of coffee used, the
humidity and various other factors. The factory setting for Espresso is about 8 grams.
Determine the desired coffee strength with a preparation test.
Milk volume
In seconds, applies to beverages with milk or milk foam.
Milk quantity depends on the milk used, the milk temperature and the milk nozzle selected. Determine
the desired volume with a preparation test.
The amount of milk foam may be smaller for the first beverage, since there is condensation
in the chilled pipes. You should therefore press the milk button briefly before preparing the
first beverage.
water volume: 37ml
OK: P Test:bev.btn.
water volume: 37ml
OK: P change: -/+
strength 100% 6,7s
OK: P change: -/+
milk volume: 28 sec.
OK: P change: -/+
The milk amount value limits the amount
of milk foam for the “milk foam on
demand” preparation.
See page 19