User manual

34
Settings
Milk volume
Milk dispensing in seconds. Applies to beverages with milk or milk foam.
Milk quantity depends on the milk used, the milk temperature and the milk nozzle selected. Determine
the desired volume with a dispensing test.
The amount of milk foam may be smaller for the first beverage, since there is condensation
in the chilled pipes. You should therefore press the milk button briefly before preparing the
first beverage.
Rest time for Latte Macchiato
When making a Latte Macchiato, the separation between the milk and the Espresso will work better if
the pause between dispensing milk and dispensing milk foam is increased.
The value can be set from 0 to 60 sec.
Sequence of dispensing of milk and coffee
First milk then coffee / First coffee then milk / Milk and coffee together.
Pre-brew
Aroma development
Pre-brew: Before brewing, the ground coffee is moistened with hot water. This causes the coffee
grounds to swell up and the aroma to develop.
Test: Each setting can be tested in the beverage settings menu.
The settings are adjusted in relation to the factory setting.
milk volume: 28 sec.
OK: P change: -/+
The milk amount value limits the amount
of milk foam for the “milk foam on
demand” preparation.
rest period: 15 sec.
OK: P change: -/+
The setting for the sequence of beverage
dispensing is only offered for beverages
with milk components.
sequ.: coffee-milk
OK: P change: -/+
The pre-brew function is set to “on” at the
factory for all coffee beverages except
Americano.
“Step by step” instruction
settings and testing
w Water volume
page 33
pre brew: on
OK: P change: -/+