User manual

33
Settings
Select the beverage settings
Press the
> Program button briefly
Use the
>
+
button to browse through to
Select the beverage setting program by pressing the
> Program button
Select the beverage for which the taste and composition should be changed
>
Water volume
Example: press the plus button until the water volume is increased to 1.25 ounces (37 ml)
>
You can start a preparation test with the new values at any time.
Place a cup under the All-in-One spout
>
Press the beverage button again >
Test the beverage >
If the beverage is to your taste, confirm the settings by pressing the > Program button
Coffee strength
The quantity of the ground coffee varies depending on the grinding degree setting, the type of coffee
used, the humidity and various other factors. The factory setting for Espresso is about 0.017 lb
(8 grams).
Determine the desired coffee strength with a dispensing test.
Cancel operation
Care button
Select / confirm
Page forward
Increase value
Page backward
Reduce value
The new values are saved when you exit
the program.
select program
browse: +
beverage settings
OK: P change: -/+
water volume: 37 ml
OK: P Test:bev.btn.
water volume: 37 ml
OK: P change: -/+
strength 100 % 6,7s
OK: P change: -/+