User manual

25
Operation
Dispensing milk and milk foam
At the touch of a button, the WMF 800 also dispenses warm milk and milk foam.
press briefly press and hold
1 cup milk Milk foam on request
All-in-One spout in the top position All-in-One spout not all the way to the top
If a beverage is selected and the All-in-One spout is not in the correct position, then a reminder is
shown on the display.
Milk or milk foam may drip out a bit after dispensing. It is best to leave the cup under the
All-in-One spout briefly after dispensing, or to place a small catch basin under the spout.
Milk can also drip out if the milk container is full and the All-in-One spout is in a lower
position. Slide the spout upward a little after dispensing a beverage.
Cup of warm milk
The All-in-One spout must be in the top position.
Place a cup under the All-in-One spout
>
Press the milk button 1x briefly >
Another press of the milk button ends dispensing prematurely.
After dispensing milk, the All-in-One spout should be slid downward slightly. The display prompts for
this.
Milk foam
The All-in-One spout must not be in the top position.
Place a cup under the All-in-One spout
>
Press and hold the milk button >
Milk foam is dispensed as long as the button is pressed.
w WMF All-in-One spout
page 27
w Settings w Cup size (Cup volumes)
page 31