User manual

19
Set-up
Water hardness
Set the result of the carbonate hardness test with the
>
–
and
+
buttons
Confirm the value with the
> Program button
After confirmation, the program jumps to the next point of the settings.
Water filter
Enter here with the
>
–
and
+
buttons whether you are using a tank filter
(recommended for water hardness gpg (°dKH) and higher)
Press the
> Program button to confirm the setting
If “water filter” is set, then the filter should be rinsed now (3 quarts / 3 liters).
> Set a container with approx. 3 quarts / 3 liters capacity under the hot water spout
CAUTION. Burning and scalding hazard.
The hot water spout can get very hot. The rinse water is very hot.
Don’t reach under the hot water spout during filter rinsing.
Never touch the hot water spout during or directly after filter rinsing.
When rinsing the filter, you will hear unusual noises. This is normal. The noises will stop during the
filter rinse.
Fill the water tank with cold tap water.
Place the lid on the water tank
>
The lid must be on the tank when it is put in place >
Slowly slide the water tank back into the machine >
The machine now heats up.
After the machine has heated up, there is a coffee system rinse. This warms up all the pipes.
After each brewing cycle, in the heating up phase and during the cleaning and maintenance programs,
release water runs into the drip tray.
Place a container for the rinse water (approx. 4 ounces / 120 ml) under the All-in-One spout
>
The coffee system rinse lasts approx. 40 seconds.
water hardn.: 13-16
OK: P change: -/+
Carbonate hardness test
w Accessories and spare parts
page 68
water lter: no
OK: P change: -/+
place 3L container
under h.w. spout
Rinse filter:
Follow the display messages
Insert the WMF water filter
w Prepare the water tank
page 14
Replace water filter
w Cleaning and Maintenance
w General care programs
page 45
heating up ...