User's Manual

Mirobot Mirobot Robot Users Manual
Document version Users Manual Beijing Tsinew Technologies Co.,Ltd.
2.Verifying the Mirobot driver
(1) Connect the Mirobot manipulator to the computer through the USB data cable.
(2) Open the device manager window. If "USB-serial ch340 (COM4)" can be found in "port
(COM and LPT)," it means that the driver is installed successfully, and the port number after com
may be different. As shown in Figure 2.8.
Figure 2.8 serial port drive information ofmanipulator
(3) Open the Mirobot Studio software. Click the Setting tab, as shown in Figure 2.9.
Figure 2.9 Setting tab of Mirobot Studio Software
Set the serial port to the com number seen in step (2), here is COM4, and then click OK. As
shown in Figure 2.10.