User manual

Industrial Cellular Router User Manual
www.wlink-tech.com 16
Figure 3-1 Cellular Settings GUI
Table 3-1 Cellular Setting Parameter Instruction
Parameter Instruction
Enable Enable SIM card dial
ICMP check
To enable or disable ICMP check rules. Enable the ICMP check
and setup a reachable IP address as destination IP. Once
ICMP check failed, router will switch SIM card.
SIM Mode Select the network type
APN
A
PN, provided by local ISP, usually CDMA/EVDO network do
not need this parameter
User
SIM card user name is provided by ISP
Password
SIM card password is provided by ISP
ICMC Check and Cellular Traffic Check is alternative.
【
ICMP Check
】
Enable ICMP, Router will automatically check whether the defined IP address is
reachable per 60s. If the IP address is unreachable and ICMP check is timeout at
the first time, it will check 2 time as 3s interval. If the third time is still failed, the
router will switch the SIM card.
The Check IP is an public IP or company server IP address.
【
Cellular Traffic Check
】
【
Check Mode
】
there are Rx(receive), Tx(Transmission) and Rx/Tx check modes.
【Rx】Router will check the 3G/LTE cellular receiver traffic. If no receiver traffic within
the defined check interval, the router will implement the specified action Reconnect
or reboot.
【SIM Mode】
【Fail Over】SIM card mutual backup. Once SIM card is failed, it will switch to the
SIM2 and work on SIM2. Once SIM2 is failed, it will switch back to SIM1.
【SIM1 Only】Just SIM1 is available.