Specifications

Regulatory Statements WM205X
5 Regulatory Statements
5.1 FCC Statements
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
This module has been approved under FCC part 15C (15.247). This modular transmitter is only
FCC authorized for this specific rule part. The host product manufacturer is responsible for
compliance to any other FCC rules that apply to the host not covered by the modular transmitter
grant of certification. (For example, Part 15 Subpart B)
The final host product must be tested for confirmation that the installation for the module into the
host is in compliance with regulations of FCC.
If testing of the host product with this transmitter installed and operating is necessary (to verify that
the host product meets all the applicable FCC rules), a test mode for this module is available upon
request to WIZZILAB.
The module is limited to OEM installation ONLY. The OEM integrator is responsible for ensuring
that the end-user has no manual instruction to remove or install module.
The module is for use with external antenna ONLY. The certified antennas include:
(1) ½ Wave Antenna with maximum gain 2.2dBi. (Dipole antenna)
(2) ¼ Wave Antenna with maximum gain -1.3dBi.
This module has been approved by FCC to operate with the antenna types above with the
maximum gain at at the antenna feed of 13dBm. Antenna types not included in this list, having a
gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this
device. Specially, if an antenna other than the model documented in the Filing is used, a Class 2
Permissive Change must be filed with the FCC.
If the end host product is equipped with an external connector, then an unique (non-standard)
antenna connector must be used on the transmitter.
A list of acceptable non-standard connectors is available upon request from WIZZILAB.
Changes or modifications not expressly approved by WIZZILAB could void the user’s authority to
operate the equipment.
IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna
used for this transmitter must not be colocated or operating in conjunction with any other antenna
or transmitter. This equipment should be installed and operated with a minimum distance 20cm
between the radiator and your body.
WIZZILAB Technical datasheet 15/17