Product Info

DWM1001C Datasheet
© Decawave Ltd 2017 Subject to change without notice Version 1.40C Page 23
10.1.4 Industry Canada (IC) Compliance Statements
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following
two conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
The OEM integrator is still responsible for testing their end-product for any additional compliance requirements
required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).
This Module is labelled with its own IC ID. If the IC ID Certification Number is not visible while installed inside
another device, then the device should display the label on it referring the enclosed module. In that case, the final
end product must be labelled in a visible area with the following:
“Contains Transmitter Module IC: 23794-DWM1001”
OR
“Contains IC: 23794-DWM1001”
Ce module est étiqueté avec son propre ID IC. Si le numéro de certification IC ID n'est pas visible lorsqu'il est
installé à l'intérieur d'un autre appareil, l'appareil doit afficher l'étiquette sur le module de référence ci-joint. Dans
ce cas, le produit final doit être étiqueté dans un endroit visible par le texte suivant:
“Contains Transmitter Module IC: 23794-DWM1001”
OR
“Contains IC: 23794-DWM1001”
10.2 Regulatory Module Integration Instructions
This module has been granted modular approval for mobile applications. OEM integrators for host products may
use the module in their final products without additional FCC / ISED (Innovation, Science and Economic
Development Canada) certification if they meet the following conditions. Otherwise, additional FCC / ISED
approvals must be obtained.
• The host product with the module installed must be evaluated for simultaneous transmission
requirements.
• The users manual for the host product must clearly indicate the operating requirements and conditions
that must be observed to ensure compliance with current FCC / IC RF exposure guidelines.
• To comply with FCC / ISED regulations limiting both maximum RF output power and human exposure to
RF radiation, the maximum antenna gain including cable loss in a mobile-only exposure condition must
not exceed:
Peak UWB Antenna Gain: 0.0dBi
Peak BLE Antenna Gain: 0.5dBi
• A label must be affixed to the outside of the host product with the following statements:
This device contains FCC ID: 2AQ33-DWM1001
This equipment contains equipment certified under IC: 23794-DWM1001
The final host / module combination may also need to be evaluated against the FCC Part 15B criteria for
unintentional radiators in order to be properly authorized for operation as a Part 15 digital device.
If the final host / module combination is intended for use as a portable device (see classifications below) the host
manufacturer is responsible for separate approvals for the SAR requirements from FCC Part 2.1093 and RSS-
102.