Data Sheet
Table Of Contents
- UM-1
- Rev. 0.2
- UM-1
- RTLS and Communication module
- Description
- Key Features
- UWB compliant, on channels 3/5.
- Embedded PCB UWB antenna.
- ETSI, FCC, ISED Certified
- FCC ID: 2ARZVUM-1, IC:27701-UM1
- Supply voltage: 2.8 V to 3.6 V
- Size: 19.1 mm x 26.2 mm x 2.6 mm
- Operating temperature: -40 C to 85 C
- Applications
- D7A over UWB communication
- WizziLab product line at
- Table of Contents
- List of tables
- 1 Overview
- 1.1 UWB Transceiver DW1000
- 1.2 Bluetooth® Microprocessor Nordic nRF52832
- 1.3 Power Supply and Power management
- 1.4 Three Axis Motion Detector
- The LIS2DH12 is guaranteed to operate over an extended temperature range from -40 C to +85 C.
- 1.5 Software on board
- 2 Pin Connections
- 2.1 Pin Descriptions
- Table 1. Pin Description
- Table 2. I2C slave devices address I2C
- 3 Electrical specification
- 3.1 Nominal operating conditions
- Table 3. Recommended operating conditions
- 4 Wireless Specification
- Table 5. UWB transceiver operating conditions
- 4.2 BLE
- Table 6. BLE transceiver operating conditions
- 5 Functionality
- 5.2 Two-way ranging
- 5.4 BLE beaconing and sniffing
- 5.5 Tap-to-connect
- 6 How to use
- 6.2 Function API
- 7 FCC Caution
- 7.2 Radiation Exposure
- 8 ISEDC Warning
- Le présent appareil est conforme Après examen de ce matériel aux conformité ou aux limites
- D03 OEM
- UM-1
- Manual v01
- 2.2 List of applicable FCC rules
- CFR 47 FCC PART 15 SUBPART C&F has been investigated. It is applicable to the modular.
- 2.3 Specific operational use conditions
- 2.4 Limited module procedures
- Not applicable
- 2.5 Trace Antenna designs
- We supply the internal PCB antenna with UWB and Ceramic Antenna with BLE.
- 2.6 RF exposure considerations
- To maintain compliance with FCC's RF Exposure guidelines.
- 2.7 Antennas
- This radio transmitter FCC ID: 2ARZVUM-1 has been approved by Federal Communications Commission to operate
- Ceramic Antenna
- 2.8 Label and compliance information
- The final end product must be labeled in a visible area with the following" Contains FCC ID: 2ARZVUM-1"
- 2.9 Information on test modes and additional testing requirements
- 2.10 Additional testing, Part 15 Subpart B disclaimer
- 9 Revision history
- Table 7. Document revision history
- 10References
FCC Caution UM-1
7 FCC Caution
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
7.1 Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
IMPORTANT NOTE: This equipment has been tested and found to comply with the limits for a
C
lass B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
7.2 Radiation Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.This device may not be employed for the operation onboard
an aircraft, a ship or a satellite is prohibited.
7.3 UWB Operation Restriction
The module UM-1 meets general requirements specified in FCC§15.519 (a)
WIZZILAB Technical datasheet 12/18