Data Sheet
Table Of Contents
- UM-1
- Rev. 0.2
- UM-1
- RTLS and Communication module
- Description
- Key Features
- UWB compliant, on channels 3/5.
- Embedded PCB UWB antenna.
- ETSI, FCC, ISED Certified
- FCC ID: 2ARZVUM-1, IC:27701-UM1
- Supply voltage: 2.8 V to 3.6 V
- Size: 19.1 mm x 26.2 mm x 2.6 mm
- Operating temperature: -40 C to 85 C
- Applications
- D7A over UWB communication
- WizziLab product line at
- Table of Contents
- List of tables
- 1 Overview
- 1.1 UWB Transceiver DW1000
- 1.2 Bluetooth® Microprocessor Nordic nRF52832
- 1.3 Power Supply and Power management
- 1.4 Three Axis Motion Detector
- The LIS2DH12 is guaranteed to operate over an extended temperature range from -40 C to +85 C.
- 1.5 Software on board
- 2 Pin Connections
- 2.1 Pin Descriptions
- Table 1. Pin Description
- Table 2. I2C slave devices address I2C
- 3 Electrical specification
- 3.1 Nominal operating conditions
- Table 3. Recommended operating conditions
- 4 Wireless Specification
- Table 5. UWB transceiver operating conditions
- 4.2 BLE
- Table 6. BLE transceiver operating conditions
- 5 Functionality
- 5.2 Two-way ranging
- 5.4 BLE beaconing and sniffing
- 5.5 Tap-to-connect
- 6 How to use
- 6.2 Function API
- 7 FCC Caution
- 7.2 Radiation Exposure
- 8 ISEDC Warning
- Le présent appareil est conforme Après examen de ce matériel aux conformité ou aux limites
- D03 OEM
- UM-1
- Manual v01
- 2.2 List of applicable FCC rules
- CFR 47 FCC PART 15 SUBPART C&F has been investigated. It is applicable to the modular.
- 2.3 Specific operational use conditions
- 2.4 Limited module procedures
- Not applicable
- 2.5 Trace Antenna designs
- We supply the internal PCB antenna with UWB and Ceramic Antenna with BLE.
- 2.6 RF exposure considerations
- To maintain compliance with FCC's RF Exposure guidelines.
- 2.7 Antennas
- This radio transmitter FCC ID: 2ARZVUM-1 has been approved by Federal Communications Commission to operate
- Ceramic Antenna
- 2.8 Label and compliance information
- The final end product must be labeled in a visible area with the following" Contains FCC ID: 2ARZVUM-1"
- 2.9 Information on test modes and additional testing requirements
- 2.10 Additional testing, Part 15 Subpart B disclaimer
- 9 Revision history
- Table 7. Document revision history
- 10References
Functionality UM-1
format.
A device, supporting the tap-to-connect protocol, can establish BLE connection with the tag. The
procedure is initiated by an NFC access event that triggers the immediate exit from monitoring
mode and disabling of all DASH7 (sub-GHz) and UWB interfaces. The tag start blinking in blue.
The tap-to connect is meant to be used as an alternative for configuration and report dumping.
WIZZILAB Technical datasheet 10/18