Data Sheet

Uplink Messages USPACE-KYD-2F
5 Uplink Messages
This section describes the reporting formats, which are of interst only the system administrator over
the dash7board WizziLab’s Cloud Service.
5.1 Status Report (FID 190)
The status message contains the main element of the configuration, the state and the battery voltage
in mV.
Example:
{
"status_param_2"=>2, "status_param_2_fields"=>{"upload"=>0, "save"=>1,
"deactivate"=>0, "alarm_pattern"=>0},
"status_options"=>18, "status_options_fields"=>{"idx"=>2, "autosleep"=>1,
"passive"=>0}, "status_mode"=>1,
"status_state"=>5, "status_state_fields"=>{"stable"=>1, "plugged"=>0, "disco_off"=>1},
"status_vbat"=>4063
}
5.2 Contact Report (FID 202)
The contact message always sends the current local timestamp in seconds
It is followed of up to 12 contact logs. Each contact log contains:
contact_uid: The UID of the contact
nb_contacts: The number of times the contact occurred (number of time the alarm was triggered)
timestamp_first_seen: The timestamp of the first alarm
seen_time: The duration between the first time the TAG is seen and the last time it has been seen
contact_time: The accumulated duration of the alarm situation
WIZZILAB Technical datasheet 16/20