Operating instructions

! WARNING
Never set the temperature beyond the vaporization temperature
recommended by your doctor or pharmacist. Setting a higher
than necessary temperature may combust the content in the
crucible, causing injury and damaging your vaporizer.
110ºC - 130ºC (230ºF - 266ºF)
140ºC - 160ºC (284ºF - 320ºF)
170ºC - 190ºC (338ºF - 374ºF)
200ºC - 220ºC (392ºF - 428ºF)
240ºC - 260ºC (464ºF - 500ºF)
The PX1’s Temperature Dial controls the amount of heat
generated to vaporize the contents in the crucible. Please
consult with your doctor, pharmacist or herb supplier for the
appropriate vaporization temperature of the herb, tobacco or
concentrate used. See below chart for the range of temperature
achieved at each dial marking.
Please note these are only approximate values that can be
reached by the contents in the crucible. Factors such as the
amount of herb or tobacco used, the blend, level of dryness, or
duration of usage will affect the actual temperature reached. If
you are unsure about the temperature to set, start with the lowest
setting. Slowly increase the temperature at each heat cycle until
you are satisfied with the amount of vapor produced.
MARKING TEMPERATURE
Selecting the Temperature
! WARNING
Use only dry herbs, pipe tobacco, and solid or gel concentrates.
If using oils or liquids, add a cotton or wool sponge to soak up
the fluid. Even a small amount of fluid seeping over the crucible
may flow onto the heating element and combust, causing
serious injury and damage to your vaporizer.
Make sure the Power is OFF. Remove the
Filter Cap by gently peeling it off the Cover.
Carefully measure and add a small, loose
amount of herb, pipe tobacco, or solid/gel
concentrate into the glass/ceramic crucible.
Use a dabber for concentrates.
Recommended amount for herb or pipe
tobacco is 1.5cc (1/3 teaspoon). Do not
overpack or fill past the Crucible glass rim.
Close the Filter Cap and pull open the
stopper.
Insert a Mouthpiece into the Filter Cap.
1.
2.
3.
4.
1
2
3
Filing the Crucible
4
12 13