User's Manual

© Copyright 2015 WIZnet Co., Ltd. All rights reserved. 37
2.5. Serial to LAN(Wired and Wireless)
 Individual settings for serial #1 and serial #2 are possible.
 Set the serial parameters for serial to wireless (Ethernet) function.
 Set two channels (Main connection, Aux connection) for each serial port
 Setting management of Serial #1 and #2 (Main connection, Aux connection)
2.5.1. Main Connection settings
Type Description
Status
Enable checked : Serial to LAN is used.
Enable un-check: Serial to LAN is not used.
Protocol
Protocol used in Serial to LAN communication
-TCP
-UDP
Mode
Serial to LAN operation mode. ( Client Mode recommended)
- Server : waits for connection.
- Client : connected to the remote server of WizFi630A
- Mixed : not recommended
Server IP
Enter the IP address for WizFi630A setting.
Server Port
Enter the port number for remote serial data server host PC.
Reconnect Interval
Interval of TCP reconnection.
Connection
Connection Type of WizFi630A’s Serial LAN. ( TCP Only )
System Bootup : connected to the remote server upon bootup.
Serial Data In : once serial data comes in, connect to remote server.
(end connection after inactive time)
Baud rate
Select the serial communication speed.
Databits
Select the databits.
Parity
Select the method for parity check.
Stopbits
Select the stopbits.
FlowControl
Select the method for flow control. (Option: none, Xon/Xoff, RTS/CTS)
2.5.2. Aux Connection Settings
Type Description
Status
Select whether to enable serial port or not.
Protocol
Protocol used in Serial to LAN communication.
Mode
Select Server or Client Mode.
Server IP
Enter the IP address for WizFi630A setting.
Server Port
Enter the port number for remote serial data server host PC.