User's Manual

WizFi360 User Manual
will be closed. (In server mode, the ID 5
has no effect.)
10.3.2.6. AT+CIFSR Gets the Local IP Address
Execute
Command
AT+C IFS R
Response
+CIFSR:APIP,<SoftAP IP address>
+CIFSR:APMAC,<SoftAP MAC address>
+CIFSR:STAIP,<Station IP address>
+CIFSR:STAMAC,<Station MAC address>
OK
Parameters
<IP address>
WizFi360 SoftAP ip address
WizFi360 Station ip address
<MAC address>
WizFi360 SoftAP mac address
WizFi360 Station mac address
Notes
•
ḕ ᐕ  䰁 ᔿ  ޣ ˈ ᖃᐕ  䰁 ᔿ Ѫ
Station 桧
 Station 䰁 ᔿ  IPǃMAC addressˈԆ 䰁  ྽ DŽ
ᖃ 撒塂 Ѫ sta ᡆ 壙 station+softap   梲 ѻˈsta
10.3.2.7. AT+CIPMUX Enable or Disable Multiple Connections
Commands
AT+CIPMUX? AT+CIPMUX=<mode>
Response
+CIPMUX:<mode>
OK
OK
Parameters
<mode>˖
▶ 0˖single connection
▶ 1˖multiple connections
Notes
• The default mode is single connection mode.
• Multiple connections can only be set when transparent transmission is disabled
(AT+CIPMODE=0).
• This mode can only be changed after all connections are disconnected.
• If the TCP server is running, it must be deleted (AT+CIPSERVER=0) before the
single connection mode is activated.
Example
AT+CIPMUX=1
10.3.2.8. AT+CIPSERVER Deletes/Creates TCP Server