User's Manual

WizFi360 User Manual
Response
+CIPSTAMAC_DEF˖<mac>
OK
OK
Parameters
• <mac>˖string parameter, MAC address of the WizFi360 Station
Notes
• The MAC address of WizFi360 SoftAP is different from that of the WizFi360
Station. Please make sure that you do not set the same MAC address for both of
them.
• Bit 0 of the WizFi360 MAC address CANNOT be 1
• ֯◌ AT+CIPSTAMAC_DEF 撒塂 Station mac ൠ൰ ˈ ሶ إ ѵ؞
WizFi360  MAC ˈ ֯◌ AT+RESTORE
ˈҏ ႌ ᚒ ༽ WizFi360  ল MAC ˈ ֯◌DŽ
• WizFi360  Station  SoftAP  MAC
ൠ൰ ᴹˈ ֯◌ 撹  撒塂
ˈ 檡  ᡆ ᚒ ༽  ল 撒塂 ˈSoftAP  MAC
Պ 愠  ˈ 擋擼
Example
AT+CIPSTAMAC_DEF=”00:08:DC:36:00:0C”
10.2.2.25. AT+CWSTARTSMART Starts SmartConfig
Commands
AT+CWSTARTSMART
Response
OK
Parameters
-
Notes
• SmartConfig is only available in the WizFi360 Station mode
• The message smart get wifi info means that SmartConfig has successfully
acquired the AP information. WizFi360 will try to connect to the target AP
• Message smartconfig connected wifi is printed if the connection is successful.
Use command AT+CWSTOPSMART to stop SmartConfig before running other
commands. Please make sure that you do not execute other commands during
SmartConfig.
• Starting from AT_v1.0, SmartConfig can get protocol type (AirKiss or
ESP-TOUCH) automatically by command AT+CWSTARTSMART.
Example
AT+CWMODE=1
AT+CW STA RT SMART
10.2.2.26. AT+CWSTOPSMART Stops SmartConfig
Command
AT+CWSTOPSMART
Response
OK
Parameters
-