User's Manual

WizFi360 User Manual
Commands
AT+CIPSTA_DEF? AT+CIPSTA_DEF=<ip>[,<gateway>,<netmask>]
Response
+CIPSTA_DEF:<ip>
+CIPSTA_DEF:<gateway>
+CIPSTA_DEF:<netmask>
OK
OK
Parameters
Notice˖
Only when the WizFi360
Station is connected to an AP
can its IP address be queried.
• <ip>˖string parameter, he IP address of the
WizFi360 Station
• [<gateway>]˖gateway
• [<netmask>]˖netmask
Notes
• The configuration changes will be saved in the flash
• The Set Command interacts with DHCP-related AT commands
(AT+CWDHCP-related commands)˖
- If static IP is enabled, DHCP will be disabled;
- If DHCP is enabled, static IP will be disabled;
- Whether it is DHCP or static IP that is enabled depends on the last
configuration
Example
AT+CIPSTA_DEF=”192.168.10.100”,”192.168.10.1”,”255.255.255.0”
- If DHCP is enabled, static IP will be disabled;
- Whether it is DHCP or static IP that is enabled depends on the last
configuration
Example
AT+CIPSTA_CUR=”192.168.10.100”,”192.168.10.1”,”255.255.255.0”
10.2.2.19. AT+CIPSTA_DEF Sets the Current IP Address of the WizFi360,
Configuration Saved in the Flash
10.2.2.20. AT+CIPAP Sets the IP Address of the WizFi360 SoftAP
Commands
AT+CIPAP? AT+CIPAP=<ip>[,<gateway>, <netmask>]
Response
+CIPAP:<ip>
+CIPAP:<gateway>
+CIPAP:<netmask>
OK
OK
Parameters
• <ip>: string parameter, the IP address of the WizFi360 SoftAP.
• [<gateway>]: gateway.