User's Manual

WizFi360 User Manual
Commands
AT+CIPSTA_CUR? AT+CIPSTA_CUR=<ip>[,<gateway>,<netmask>]
Response
+CIPSTA_CUR:<ip>
+CIPSTA_CUR:<gateway>
+CIPSTA_CUR:<netmask>
OK
OK
Parameters
Notice˖
Only when the WizFi360
Station is connected to an AP
can its IP address be queried.
• <ip>˖string parameter, he IP address of the
WizFi360 Station
• [<gateway>]˖gateway
• [<netmask>]˖netmask
Notes
• The configuration changes will be saved in the flash
• The Set Command interacts with DHCP-related AT commands
(AT+CWDHCP-related commands)˖
- If static IP is enabled, DHCP will be disabled;
10.2.2.17. AT+CIPSTA Sets the Current IP Address of the WizFi360 Station
Commands
AT+CIPSTA? AT+CIPSTA=<ip>[,<gateway>,<netmask>]
Response
+CIPSTA:<ip>
+CIPSTA:<gateway>
+CIPSTA:<netmask>
OK
OK
Parameters
Notice˖
Only when the WizFi360
Station is connected to an
AP can its IP address be
queried.
• <ip>˖string parameter, he IP address of the
WizFi360 Station
• [<gateway>]˖gateway
• [<netmask>]˖netmask
Notes
• The configuration changes will be saved in the flash
• The Set Command interacts with DHCP-related AT commands
(AT+CWDHCP-related commands)˖
- If static IP is enabled, DHCP will be disabled;
- If DHCP is enabled, static IP will be disabled;
- Whether it is DHCP or static IP that is enabled depends on the last
configuration
Example
AT+CIPSTA=”192.168.10.100”,”192.168.10.1”,”255.255.255.0”
10.2.2.18. AT+CIPSTA_CUR Sets the Current IP Address of the WizFi360,
Configuration Not Saved in the Flash