User's Manual

WizFi360 User Manual
C
omm
ands
AT+CWJAP_CUR?
A
T+CWJAP_CUR=<ssid>,<pwd>[,
<bssid>]
Re
sponse
+
CWJAP_CUR:<ssid>,<
bssid>,
<chan
nel>,<rssi>
OK
OK
or
+
CWJAP_CUR:<error code>
FAIL
P
arame
ters
• <ssid>˖the SSID of the target
AP
•
<bssid>˖the target AP’s
MAC
address
•
<channel>˖channel
•
<rssi>˖Signal strength
• <ssid>˖the SSID of the target AP
•
<pwd>˖password, MAX: 64-byte ASC
II
•
[<bssid>]˖optional parameter, the targ
et
AP’s MAC address, used when
multiple
APs have the same SSID.
•
<error code>˖(IRU UHIHUHQFH RQO
\)
▶ 1˖connection timeout.
▶ 2˖wrong password.
▶ 3˖cannot find the target AP.
▶ 4˖connection failed.
Thi
s command requires Station mode to
be
enabled.Escap
e character syntax is needed
if
SSID or password contains any special
• <channel>˖channel
• <rssi>˖Signal strength
ASCII.
• [<bssid>]˖optional parameter, the
target AP’s MAC address, used
when multiple APs have the same
SSID.
• <error code>˖ (IRU UHIHUHQFH
RQO\)
▶ 1˖connection timeout.
▶ 2˖wrong password.
▶ 3˖cannot find the target AP.
▶ 4˖connection failed.
This command requires Station mode to
be
enabled.Escape character syntax is
neede
d if SSID or password contains
an
y special characters, such as ,or ” or
\.
Note
• The configuration changes will be saved in the flash.
• If multiple APs have the same SSID, the target AP can be found by BSSID
Exam
ples
A
T+CWJAP=”WIZnet”,”wiznet2018”,”f4:83:cd:9e:d4:40”
10.2.2.5. AT+CWJAP_CUR Connects to an AP; Configuration Not Saved in
the Flash