User's Manual

WizFi320 User Manual
© Copyright 2021 WIZnet Co., Ltd. All rights reserved. 40
Set Command
Command:
AT+WPS=<enable>[,<auth floor>]
Response:
OK
Parameters
• <enable>:
o 1: Enable WPS (Wi-Fi Protected Setup) that uses PBC (Push
Button Configuration) mode.
o 0: Disable WPS that uses PBC mode.
• <auth floor>: Wi-Fi authentication mode floor. ESP-AT will not connect to
the AP whose authmode is lower than this floor.
o 0: OPEN (Default)
o 1: WEP
o 2: WPA_PSK
o 3: WPA2_PSK
o 4: WPA_WPA2_PSK
o 5: WPA2_ENTERPRISE
o 6: WPA3_PSK
o 7: WPA2_WPA3_PSK
Notes
• WPS can only be used when the ESP station is enabled.
• WPS does not support WEP (Wired-Equivalent Privacy) encryption.
Example
AT+CWMODE=1
AT+WPS=1
AT+MDNS: Configure the mDNS Function
Set Command
Command:
AT+MDNS=<enable>[,<hostname>,<service_name>,<port>]
Response:
OK
Parameters