User's Manual

WizFi 210 User Manual (WIZnet Co., Ltd.)
27
Ex) AT+NAUTO=0,1,192.168.3.101,5000
(TCP/Client)
AT+NAUTO=1,1, ,5001 (TCP/Server)
AT+NAUTO=0,0,192.168.3.101,5002
(UDP, Local/Remote Port is 5002)
ATC n=0 (disable) =1 (enable)
IF 1, Auto Connect is enabled on next reboot
or AT.
ATA Start Auto Connect, including association.
ATA2 Start Auto Connect using existing association.
ATO
Return to a previous Auto Connect session;
returns an error if no such session exists.
Table 24. Auto connection
(12) Provisioning
Command Parameters Responses / Effects
AT+WEBPROV
=
<user name>,<passwd> Provisioning through web pages
AT+WEBLOGO
ADD=
<size> maximum size is 1788
bytes
Adding the Logo that will appear on the web
pages used for provisioning.
Table 25. Provisioning
(13) Miscellaneous
Command Parameters Responses / Effects
AT+FWUP=
<SrvIp>,<SrvPort>,<SrcPort>,[<ret
ry>]
Get a firmware upgrade from the server
address/port to the adapter port SrcPort.
Ex) AT+FWUP=192.168.3.200,667,667
AT+SETTIME= <dd/mm/yyyy>,<HH:MM:SS> Set the adaptor system time
AT+
GETTIME=?
Upon reception of this command the adaptor
sends the current system time in milliseconds
since
epoch(1970) to the serial interface. The time
format comes on the serial interface as
follows:
“Current Time in msec since epoch=xxxxxxx”
AT+DGPIO= <GPIO-NO>,<SET/RESET(0/1)>
Set or reset (high/low) a GPIO pin
Ex) AT+DGPIO=31,0
AT+VER=? Return the current adapter firmware versions.
AT+PING=
<IP>,[[Trails],[<Interval>],[<Len>],[ PING the IP address provided. Trails = 0 will