User's Manual

WIZ6000 User’s Manual
(WIZnet, Inc.)
35
※ The above test can also be performed in a program called, “Device Terminal program”, which
is easy and simple to use.
Figure 36. Device Terminal Program
Device Terminal is a program which integrates both serial and network communications into one
user interface so that you can test your WIZnet gateway module easily.
As shown in above Figu re, the upper p art of the program allows you to config ure your serial
setting of WIZ6000. By clicking the “Open” button, serial communication is enabled.
The lower part of the p rogram allows you to configure the network settings. You can test both
TCP Clie nt a nd TCP Se rver modes at the sam e time. If the Server Mod e is enabled, Devi ce
Terminal will operate as server mod e, and the WI Z6000 module will work as client mode. The
PC whe re th e Device T erminal is op erating w ill wo rk as a server, the IP address of the PC
should be set as Server IP of the module. If Se rver mode is not che cked, Device Terminal will
operate as cl ient mode, and the module as serve r. For the IP ad dress an d port, please inp ut
your IP address and port number of WIZ6000 a nd click the “Connect” button to start a network
communication.
When serial and network terminals are connected, input any character in the Data Input window
and click “Send” button. You can check the data is transferred into the another window.