User's Manual

WIZ6000 User’s Manual
(WIZnet, Inc.)
28
2.2.7.3 Upgrade
In this page, you can upgrade the firmware of your WIZ6000.
Browse the firmware file b y clicking the “Find” button. If you click “Upload” button after selecting
firmware file, the firmware starts uploading. This process will take about 60 seconds.
Figure 27. Upgrade Firmware
2.2.7.4 Factory Default
If you click the “Fa ctory Default” b utton, all se ttings value are resto red to the factory de fault
setting. The factory default values are shown below:
Field Default Value
IP Address 192.168.1.254
Subnet Mask 255.255.255.0
Default Gateway 0.0.0.0
DHCP Serv er
DHCP Client Range 192.168.1.2~192.168.1.100
DNS Server 0.0.0.0
Serial Status Disable
Serial Mode Server
Server IP 0.0.0.0
Server Port 5000
Baudrate 3840 0
Databits 8
Parity N one
Flow Control None