User's Manual

WIZ6000 User’s Manual

(WIZnet, Inc.)

Figure 18. WDS Setting

Input wireless MAC address of the device to be connected.

Apply Changes: Add the MAC address into the WDS list

Reset: Discard all changes in all fields.

2.2.4.4 Gateway Setup

Notice

When changed to Gateway mode, wired netwo rk is disco nnected, It becau se WIZ6000’s wire

port act as WAN Port. So to solve this problem..

1. Connect WIZ6000 through wireless

2. Check WAN IP of Gateway mode setup page

3. Connect ‘http://WAN_IPaddress:8080 (8080 port)

First time it must be input ‘8080’, but next time no need to add ‘8080’

Gateway mode can be used when you want to conn ect to the Internet thro ugh an ADSL/Cable

Modem, or IP Sharing Device. By clicking the “Setup” button, you can configure your PPPoE,

DHCP Client, PPTP or Static IP settings