User manual

WIZ-600Wi User Manual

5. Serial Converter Operation Test

Serial-to-Wireless function can be implemented by using ‘Serial Converter’ function. In this

manual, the testing will be performed by using PC supporting wireless LAN and serial port. Device

Terminal program is used for checking data communication. Device Terminal program can be

downloadable at the WIZnet Homepage (http://www.wiznet.co.kr)

Figure 21. Serial Converter Block Diagram

STEP 1> Plug the WIZ600Wi module into the base board and connect the serial cable and power

adaptor. In this test, serial cable is connected to PC. When connecting to another serial device, the

serial cable will be connected to the device.

STEP 2> After more than one minute for the booting, connect to the module through web

browser to enable ‘Serial Converter’ function. In chapter 2.1, the connecting method through web

browser is described in detail.

STEP 3> Click ‘System’ menu, and check ‘Use Serial Converter’ of UART CONFIGURATION. In this

testing, the module is configured as below,

- IP address : 192.168.1.200

- Serial Baud Rate : 9600bps

For the detail, refer to the <Figure 22>