User manual

WIZ-600Wi User Manual
© Copyright 2008 WIZnet Inc. All rights reserved
27
à UART(RS232) CONFIGURATION
- Use Serial Converter : It selects using RS232 data transmission mode or not.
- Operation Mode : RS232 data transmission should be processed through server
and client type. If one side operates as server, the other side does as client.
- Server IP : When operated as Client mode, input server IP address. At the server
mode, this value is ignored.
- TCP Port : Input TCP port number for data transmission. The same value should
be applied for both of server and client.
- Use Flow Control : It selects ‘Use Flow Control’ for RS232 communication.
- Baud rate : It configures baud rate for RS232 communication.
- Data Bit : It configures data bit
- Parity : It configures parity value
2.2.8. Administrator
Figure 14. Configuration Tool – Administrator
à USER CONFIGURATION
It configures AP name, user ID and password.
- AP Name : It configures the name of current AP.
- User Name : It configures User ID to be connected to the AP.
- Password : It configures User Password to be connected to the AP.