User manual

WIZ-600Wi User Manual
© Copyright 2008 WIZnet Inc. All rights reserved
17
2.2.1. Wireless
It configures wireless interface of AP.
à RADIO CONTROL
- AP MODE : Configure as Enable for Access Point
à BASIC WIRELESS CONFIGURATION
- Operation Mode
Operation mode can be configured after wired connection is established.
The connection can be closed at the wireless connection.
z Access Point : WIZ600Wi operates as Access Point.
z Station : WIZ600Wi operates as Station for the connection to another
access point.
z Repeater : WIZ600Wi operates as Repeater
- SSID Hide : This function hides SSID in the Beacon packet that Access point
sends for the security. If this function is enabled, the SSID is not shown when a
client searches the Access Point. However, if Client has the information of the
SSID and specifies it when searching Access point, it can search the Access Point.
- Use VLAN : It configures VLAN Tag of related SSID.
- SSID : It configures SSID of 2.4GHz wireless interface. The multi-SSID is
supported. You can use max 4 SSIDs.
- Wireless Channel : It configures frequency that 2.4GHz wireless interface will
use. In case of Auto CH Select, the most suitable channel is selected after
searching the frequency.
- Wireless Mode : It configures wireless mode that 2.4GHz wireless interface will
use. 2.5GHz wireless interface can configure 11g and 11b. If ‘Mixed 802.b/g
mode’ is selected, the wireless client supporting both of 11b and 11g, can
connect to AP. If ‘802.11b only’ or ‘802.11g only’ is selected, the client
supporting each mode, can connect to the AP.
- Tx Rate : It configures transmission speed. According to the mode, the speed
can be different. If ‘best’ is selected, AP automatically operates with the best
transmission speed.
- Tx Power : It configures radio transmission output.