User Manual

Page 5
System assembly
1. Open backpack top compartment zipper 1a
(notice that this is the second zipper from top)
2. Place STAC 4 on #1 boom pole 3a left or right
side, according to your preferences, make sure
STAC 4 locking handle is in its open position.
3. Open Velcro port 1b on your preferable side,
left or right.
4. Slide narrow (male) end of boom pole 3b
through the Velcro port into pole 3a
5. Make sure that the reduced diameter section
of pole 3b is fully inserted to pole 3a
6. Push and lock STAC handle until it touches the
clamp body
7. Follow “Adjusting the STAC” instruction
chapter as how to adjust clamping force on
page 7
Left hand side assembly
Right hand side assembly