User Manual

Page 19
Disassembly & Reassembly of the base plate
Disassembly
1. Release all poles from backpack
2. Release and remove the base plate holding straps 2a
from buckle 1g
3. Completely open main zipper 1c
4. Completely open vertical plate straps 1k
5. Completely open horizontal plate straps 1l
6. Take the plate out
Assembly
1. Open main zipper 1c completely down
2. Move the inner harness straps (1k, 1l) to the sides and insert the plate
3. Insert your hand to the bottom of the base plate and pull base plate stabilizing straps 2a through right and
left backpack waist straps outlets.
4. Run the base plate stabilizing straps 2a through 1g buckles and make initial fastening
5. Close inner harness vertical straps 1k. Make sure base plate is in correct position and tighten the 1k straps
6. Close inner harness horizontal straps 1l. Make sure base plate is in correct position and tighten the 1l straps
7. Make final fastening of all straps: 1k, 1l and 2a. Make sure that plat seats tightly inside the backpack.
8. Close the main zipper 1c