User Manual

Page 18
Poles disassembly instructions without a sleeve:
1. Disconnect your camera by opening bolt 6a
2. Fully retract pole 3d into pole 3c
3. Open pole 3c-3b STAC 4 and disconnect the pair 3c-3d from 3b pole
4. Insert poles 3c-3d to backpack main compartment as seen in the picture
5. Insert the STACs to one of the backpack compartments
6. Secure the backpack main zipper by opening 1j Velcro and inserting it
to the second zipper pull tab (see zoomed picture)
Using your CU2pack as Hydration backpack
With plate & poles
You can add a water bladder (approx. 1 liter) to the backpack, while using the system for camera shooting. Use
CU2pack water bag webbing 1m to hang water bladder inside the backpack. Take bladder tube out through left
or right water tubes outlets 1d.
Without plate & poles
For storing larger amount of water and/or additional items, you may disassemble the base plate from the
backpack and use it as a standard high quality hydration backpack. Follow the instruction in the next section
"Disassembly & Reassembly of the base plate".