User Manual

Page 15
Camera securing leash kit (optional)
Built from 2 separate cords to enable easy dismantling and assembly of the system, the leash kit is designed to
secure your camera as well as all CU2pack components. The leash runs through the inside of all boom poles and
attaches your camera (via a dedicated leash outlet) to the backpack support plate. We highly recommend using
the leash at all times, especially during water sports.
Assembly instructions
Short cord section
1. Insert the short cord loop 13b through one of
the pole 3a sides and pull it out through the pole
center hole
2. Slide the loop around pole opposite side to get a
secure connection of the cord to the first pole
Long cord section
1. Slide the long cord loop 13c along
pole 3d until you reach the leash
outlet 7
2. Insert the other side of the long
cord into the leash outlet and pass
it through Pole 3d and 3c (with
clamp attached)
3. Tie the cord end to the metal ring
13d
Leash short cord assembly
Leash short cord assembly
Leash long cord assembly