User Manual

Page 14
Waist Harness kit (Optional)
Designed to be used in sports where a waist
harness is used (kitesurfing, windsurfing,
snowkiting, etc.). Keeps the CU2pack from
riding up on your back while surfing. The
waist harness kit clips on the bottom of your
waist harness to stabilize and keep the
CU2pack in place.
The kit includes:
12a 2 special buckles
12b 2 40cm straps
12c 2 stainless steel clips
Assembly instructions
Open the top part of the special buckles 12a
and slide them through the backpack
webbing loops 1h. Close the buckle to lock it
to the webbing.
After wearing and adjusting your harness, wear the backpack, and clip the stainless steel clips 12c to the bottom
of your harness. Fasten straps 12b so the backpack is pulled towards harness bottom
Note: Clips 12c have some flexibility. If your harness is thicker than their opening, you can increase the gap of
their opening by holding both sides of the clip and slightly pulling apart.