User Manual

Page 12
Adjusting your camera position & angles
1. Assemble the whole system with your camera as explained in previous sections
2. Adjust camera position using the 3 joints. Start with the first joint (connects 3a-3b) that is located inside the
pack. Then adjust the second joint (connects 3b-3c) and finally adjust the third joint (3c-3d) that controls
system length as well as orientation.
3. Wear the backpack and fasten the waist strap. Look at the system and camera and roughly check if you
achieved the desired POV (Point Of View). If not, remove the backpack, re-adjust the joints and repeat this
step.
Note: Take your time in the first few times that you use the system to practice different camera positioning by
changing the orientations between the poles. Take into consideration, that the first joint setting, is affecting the
motion of the second joint, and therefore you may find it a bit tricky in the first usage. Once you practice, it will
become easier to use.
4. Once the camera seems to be in the right position, adjust camera angles using 6a, 6b and 6c bolts
5. Operate the camera and watch its image by smart phone or other means supplied by the camera maker. If
such means are not available, we suggest that in the first times, you operate your camera and watch the
recorded result.
6. Once you are satisfied with the POV, make sure that all clamps are fastened enough and that camera
assembly bolts are fasten with a screwdriver.
Note: When you check the camera image, make sure to position your body as if you are doing your sport (for
example, if your are biking, seat on the bike in a riding position, and check the image)