User's Manual

③ Press the mode button for more than 2seconds while the active switch is pressed by finger.

④ When the counter ID is displayed as “ConXXX” on the LCD screen, press the mode button

shortly and move to “LEAVE”.

⑤ When the “LEAVE” is displayed in the LCD screen, press the mode button twice shortly to

select it.

 “LEAVE” does not blink if “LEAVE” is selected correctly.

 If it blinks, select again.

⑥ After selecting “LEAVE”, press the mode button shortly to move to the channel of the

repeater that is displayed at the bottom of the screen.

⑦ Press the mode button twice shortly to select the channel.

 “CHX” does not blink If “CHX” is selected correctly.

 If it blinks, select again.

⑧ When the channel selection is complete, the antenna icon will be displayed on the LCD.

 The connected “Repeater CH” will be displayed at the bottom of the SMMS program.

⑨ Click “Search” in SMMS(Smart Mold Management System) to check the connected counter.

 Select an added counter at the table.

⑩ Enter “0” in “Shot count” text box, select “Transmission cycle” and click “Set device”

button.

 The counter ID is allocated automatically.

2) Delete

① Select “System” “Counter” menu.

② Select a counter to delete at the table.

③ Click “Delete” button at the upper-right side.

④ The deleted counter information will be disappeared at the table.

④

⑤

⑥

⑦