User Manual

22
Setting up the Desktop
Note: You cannot connect the cable or infrared device to a
parallel port.
Connecting the QuickLink
Communications Cable
The QuickLink communications cable has a connector at
each end, which must be attached to the appropriate
hardware:
• 9-pin serial connector for attaching to the serial port on
the computer
• Cable plug for attaching to the Pen
To connect the cable:
1. Locate the 9-pin serial port on the back of your computer.
Plug the 9-pin serial connector into the serial port.
2. Insert the cable plug firmly into the PC link connector
on the bottom of the Pen.
Connecting an External Infrared Device
The external infrared device has a 9-pin connector at one
end, which must be attached to the back of the computer. To
connect the device, plug the connector into the serial port on
your computer.