User manual

The WizCom Desktop
39
Pen-PC Communication Settings
There are four ways in which the Pen communicates with
the PC via the Desktop application:
 Send Stored Files to PC (initiated by Pen)
 Scan to PC (initiated by Pen)
 Optimize Pen File System (initiated by Desktop)
 Launching the Add\Remove Pen Components
dialog (initiated by the Desktop)
When communicating with the PC, the Pen must be
connected to the PC using the cable provided with the
Pen.
Communication Settings
The Communications Settings dialog box (accessed
from the Pen-PC Communications menu on the Menu
Bar) allows the following information to be modified:
 The type of communications (either Cable or Infra-
Red).
 The communications port on the computer to which
the connection device is associated.
 The communications baud rate (the speed at which
the data is transmitted), if you are using a cable.
 The Infra-Red driver, if you are using Infra-Red
communications.
Communications settings must be defined correctly on
both the Pen and Desktop in order for the two to
communicate. See Establishing Pen-PC
Communications on page 9 to configure the correct
communication settings for both the Pen and PC.
Desktop Modes - Turn Pen
Communications Off/On
The Desktop application runs in two modes - online or
offline. The default mode is online.