User's Manual

radiator circuitry is enabled. Testing laboratories may need to add attenuation
or filters depending on the signal strength of any active beacons (if applicable)
from the enabled radio(s). See ANSI C63.4， ANSI C63.10 and ANSI C63.26 for
further general testing details.
When testing for emissions from the unintentional radiator， the transmitter shall
be placed in the receive mode or idle mode， if possible. If receive mode only is
not possible then， the radio shall be passive (preferred) and/or active scanning.
In these cases ， this would need to enable activity on the communication BUS
(i.e.， PCIe， SDIO， USB) to ensure the unintentional
The product under test is placed into a normal ‘paired' mode with another wifi
device, as per the normal intended use of the product (for example, transferring
data).
FCC Statement：
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
ISED RSS Warning: This device complies with Innovation, Science and
Economic Development Canada licence‐
exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
ISED RF exposure statement:
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator& your body.This transmitter must not be
co‐located or operating in conjunction with any other antenna or transmitter. Le
rayonnement de la classe b repecte ISED fixaient un environnement non
contrôlés.Installation et mise en œuvre de ce matériel devrait avec échangeur
distance minimale entre 20 cm tonon corps.Lanceurs ou ne peuvent pas coexister
cette antenne ou capteurs avec d’autres.