Product Manual

Model WR 41
Push on the tab to expose the battery holder
Pull the holder completely out of the protractor
Insert a CR2032 battery into the holder with the
plus side down
Re-install the holder
8” DIGITAL PROTRACTOR & RULE
Battery Installation
Wixey
TM
PROBLEM
Flashing Digits
No Display
No Display
Erratic or
Frozen Display
Low Voltage
Low Voltage
Bad Contact
Internal Error
Replace Battery
Replace Battery
Clean Battery
Remove Battery
Wait 1 Minute
and Replace
POSSIBLE
CAUSE
SOLUTION
Always turn off and unplug power tools before
using the Digital Protractor
Never use your power tools without properly
installed blade guards. The guards may not be
shown in our instructions only to make the
illustrations clear.
ON/OFF
• Short press to turn on or off the display only
• Press and hold 3 sec. to shut down completely
• Auto shut off after 6 minutes (display only)
• Moving the arms turns the display on unless shut down
ZERO
• Press at any position to set display to 000.0
Setting to 000.0 with the arms opened up flat
120.0 degrees
60.0 degrees
Setting to 000.0 with the arms folded flat together
SAFETY FIRST