Product Manual

Measuring and cutting:
29. With the CJ4000 set in measuring
mode fit it into the corner making sure
both the left and right sides fit properly.
30. Both pieces of molding should contact
both the ceiling and wall along their entire
length.
32. Holding the CJ4000 in position,
press the HOLD LEFT or HOLD RIGHT
button. Pressing the HOLD RIGHT
button will show a display similar this.
31. For an inside wall corner angle of 90.7º
and using a 38º spring angle the display will
look like this.
33. The display in 32. illustrates the following:
a. Displays cutting the right piece of trim
b. The display is set to show only bevel left
c. The bevel angle will be set to 33.6º
d. The miter angle will be set to 31.3º
e. The trim to keep is to the left of the blade
f. The bottom of the trim is against the fence
g. The saw is mitered to the left
h. The saw is beveled to the left
7
29
30
31
32
33