Product Manual

Calibration:

BEVEL function:

There are 2 types of compound miter saws. Dual Bevel saws will tilt both to the left and

to the right. Single Bevel saws will tilt only to the left. Selecting DUAL BEVEL will have

the graphics display show the cut orientation used for tilting the saw both directions

while selecting BEVEL LEFT will show the orientation used for tilting the saw only to the

left. You can toggle this setting back and forth anytime without affecting any of the other

settings. The actual bevel angles and miter angles displayed will not change and are the

same values for both methods.

11. Loosen the lock knobs and rotate the

protractor so the display is facing up and

the arms are angled as shown. Place it on

a flat surface and make sure the backs of

the trim pieces are lying flat.

12. Re-tighten the lock knobs.

13. Using a square, carefully align the top

edges of the trim so that they are at a 90º

angle to each other.

14. Keeping the trim pieces flat and at 90º to each other, press and hold the CAL button to

set the display values to 90.0º SPRING angle and 90.0º WALL angle.

Press and hold