User manual

101

USER MANUAL

3.2) WT-1010C2 Inputs and Outputs Wiring Instructions

ZONE1(RLY1), ZONE2 (RLY2), ZONE3 (RLY3) Remote Controlling Outputs

Connect ZONE1, ZONE2 and ZONE3 to additional outputs for remote controlling. These open

collector outputs can be turned on and off remotely through a SMS. Remote control will be

reachable by sending a SMS with a certain command.

Note: When sending normal SMS with command below, the WT-1010C2 will turn On

/ Off the output relay and reply a message of output has turned On / Off to a

programmable phone numbers.

ZONE4 (IN1), ZONE5 (IN2), ZONE6 (IN3) Inputs

Connect ZONE4, ZONE5 and ZONE6 to inputs panel, when there is a short-circuit impulse on

(ZONE4, ZONE5, ZONE6), the WT1010C2 is possible to send SMS to a programmable phone

numbers.

For Example: ZONE4 is connected to a electrical door, when there is intruder or the

electrical door is opened illegally, WT1010C2 will receive short-circuit impulse on ZONE4 and

will automatically send a signal to the monitoring station and also send a SMS to notify the

owner.

WT1010C2 – USER MANUAL – Rev.2.7 – Technical Support : Technical@witura.com