User manual

101

USER MANUAL

7. Sends text messages to user programmable cell phone number (SMS): The

WT-1010C2 can be programmed to send a SMS to a programmable cell

phone number to notify the user that the PSTN line has been cut off or

unavailable.

8. Wireless Listening Device – The WT-1010C2 has a built-in microphone that

can be used for security and surveillance purposes. With this feature, it allows

the user to observe the surrounding or the area of the unit.

9. Low power consumption - uses 30mA while in idle state and 260mA when

transmitting an alarm

10. Wall mounting enclosure available: The WT-1010C2 units can be installed

inside the alarm panel or inside its own wall mount enclosure.

3. Installation Instructions

Note: It is essential that you read the step by step instructions fully prior to

installing and programming the unit

3.1

)

Descri

tion

1. Antenna: connect the antenna to the GSM module; place the antenna as far

as possible from the WT-1010C2 and do not leave any coiling of the antenna

cable to avoid radiant interference

2. SIM Card: disable the PIN code and set it to 1234 (default)

For Transmitter Mode (Data or SMS): as with any transmitter, it requires an

identifier, receiver telephone numbers, etc (refer to the complete information

on Programming page)

3. Line Input: connect the line input to the PSTN or ISDN network.

4. Outputs(Back-Up Mode): connect the RS232 DB15 to additional remote

controlling outputs.

5. Alarm Input: connect the input to output of the Alarm Panel / Control Panel.

6. Power Supply: connect to a 12V power supply

7. Operating State: Approximately 20s after power up, check the operating

state indicated by the Power LED: the LED is steady during power up phase,

then blinks when the connection to the GSM network is established. The Signal

indicator LED will stay lit whenever there is signal.

WT1010C2 – USER MANUAL – Rev.2.7 – Technical Support : Technical@witura.com