User manual

WT
-
101
0
C2
USER MANUAL
Return Message
AREA-OK
5.14 Setting the Function of Adding Area Code when Transmitting an Alarm
The system has the function of adding area code automatically when dialing the
number from the alarm panel. It is possible to enable or disable this function by
sending the following SMS command to the unit.
Text Command:
*AROF#X
X stands for ON (1) or OFF (0) value
When *AROF#1 is applied, it will add the programmed area code in front every time it
dials the number from the alarm panel.
When *AROF#0 (Default) is applied, it will not add the programmed area code in
front every time it dials the number from the alarm panel.
To enable this function, you would send *AROF#1 SMS command to the unit.
Return Message
AROF-ON
5.15 Setting the Delay Time for Transmitting a Dialing Number
The unit can be set to transmit a dialing number within a specific time. To program the
delay time of transmitting a dialing number, you can send the following SMS command
to the unit.
Text Command:
*DATM#XXXXX
XXXXX stands for 5 digits value: the number of seconds (00000-65535)
When *DATM#00007 is applied, the system will send out the dialing number to the
programmable administrator/central station number within 7 seconds.
Return Message
40
WT1010C2 – USER MANUAL – Rev.2.7 – Technical Support : [e-mail]
COPYRIGHT ©2008 WITURA CORPORATION SDN BHD