User manual

101

USER MANUAL

When *RLR1#0 is applied, means when Relay 1 has turned off, it will not send any

message to the programmable administrator number 1.

To enable this function for output 1, you would send *RLR1#1 SMS command to the

unit.

Return Message

RLR1-ON

5.12 Setting the Waiting Time for Engaged Call

In the event the administrator has not answered the call or engaged, it could take a

while for the WT-1010C2 to call the next number. You can shorten the time for every

call by sending the following SMS command to the unit.

Text Command:

*WAIT#XX

XX stands for 2 digits value: the number of seconds (20 – 60)

Example:

To program the waiting time to 20 seconds, you would send *WAIT#20 SMS

command to the unit.

Return Message

*WAIT-TIME#=20

5.13 Programming the Area Code into WT-1010

To program the area code into the system, you can send the following SMS command

to the unit.

Text Command:

*AREA#XXXX

XXXX stands for 4 digits value: Area Code

Example:

To program area code 04, you would send *AREA#04 SMS command to the unit.

WT1010C2 – USER MANUAL – Rev.2.7 – Technical Support : Technical@witura.com